wiki.ryliejamesthomas.net

User Tools

Site Tools

Trace:
roland_tr-8

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
roland_tr-8 [2024/05/22 20:30] – Started MIDI section, added tinyloops link, still needs a reorg rjtroland_tr-8 [2025/05/08 16:34] (current) – [Notes] Note on accent/velocity rjt
Line 11: Line 11:
 FIXME → Add the .INS and other files I use. FIXME → Add the .INS and other files I use.
  
-FIXME → Add table of MIDI CC info, etc.+==== Notes ==== 
 + 
 +I can't remember where I got the info for the accent, delay, and reverb notes, but reverb and delat work when I send through [[Reaper]]. I've never had luck with getting accents to actually do anything though, so to get the same effect I increase the velocity CC value by 27. The default, unaccented value, seems to be 80? 
 + 
 +This is for TR-8s with the 7×7 upgrade. 
 + 
 +| 12 | //Accent// NB: see above | 
 +| 14 | //Reverb// | 
 +| 16 | //Delay// | 
 +| 35 | Bass Drum 2 | 
 +| 36 | Bass Drum | 
 +| 37 | Rim Shot | 
 +| 38 | Snare Drum | 
 +| 39 | Hand Clap | 
 +| 40 | Snare Drum 2 | 
 +| 42 | Closed Hi-hat | 
 +| 43 | Low Tom | 
 +| 46 | Open Hi-hat | 
 +| 47 | Mid Tom | 
 +| 49 | Crash Cymbal | 
 +| 50 | High Tom | 
 +| 51 | Ride Cymbal | 
 +| 54 | Tambourine | 
 +| 56 | Cow Bell | 
 + 
 +==== Control Change Messages ==== 
 + 
 +All of the controls are accessible via MIDI CC messages. These are: 
 + 
 +| 9 | Shuffle | 
 +| 12 | Ext. In Level | 
 +| 13 | Ext. In Side Chain | 
 +| 16 | Delay Level | 
 +| 17 | Delay Time | 
 +| 18 | Delay Feedback | 
 +| 20 | BD Tune | 
 +| 21 | BD Attack | 
 +| 22 | BD Comp | 
 +| 23 | BD Decay | 
 +| 24 | BD Level | 
 +| 25 | SD Tune | 
 +| 26 | SD Snappy | 
 +| 27 | SD Comp | 
 +| 28 | SD Decay | 
 +| 29 | SD Level | 
 +| 46 | LT Tune | 
 +| 47 | LT Decay | 
 +| 48 | LT Level | 
 +| 49 | MT Tune | 
 +| 50 | MT Decay | 
 +| 51 | MT Level | 
 +| 52 | HT Tune | 
 +| 53 | HT Decay | 
 +| 54 | HT Level | 
 +| 55 | RS Tune | 
 +| 56 | RS Decay | 
 +| 57 | RS Level | 
 +| 58 | HC Tune | 
 +| 59 | HC Decay | 
 +| 60 | HC Level | 
 +| 61 | CH Tune | 
 +| 62 | CH Decay | 
 +| 63 | CH Level | 
 +| 68 | Scatter Type | 
 +| 69 | Scatter Depth | 
 +| 70 | Scatter SW | 
 +| 71 | Accent | 
 +| 80 | OH Tune | 
 +| 81 | OH Decay | 
 +| 82 | OH Level | 
 +| 83 | CC Tune | 
 +| 84 | CC Decay | 
 +| 85 | CC Level | 
 +| 86 | RC Tune | 
 +| 87 | RC Decay | 
 +| 88 | RC Level | 
 +| 89 | Reverb Time | 
 +| 90 | Reverb Gate | 
 +| 91 | Reverb Level |
  
 ===== Notes ===== ===== Notes =====
Line 42: Line 120:
 As well as using ''STEP'' to have reverb and delay only on certain steps, you can can limit them to certain instruments (very handy!). Press ''KIT'', then hold ''STEP'' on reverb or delay, then toggle things on and off with their buttons under the sliders. As well as using ''STEP'' to have reverb and delay only on certain steps, you can can limit them to certain instruments (very handy!). Press ''KIT'', then hold ''STEP'' on reverb or delay, then toggle things on and off with their buttons under the sliders.
  
-You can also use different reverbs and delays. Go into instrument mode (''INST''), then press ''STEP'' in the reverb or delay areas.+You can also use different reverbs and delays. Go into instrument mode (''INST''), then press ''STEP'' in the reverb or delay areas and select them with the pads. 
 + 
 +Reverbs: 
 + 
 +  - Non-attack 
 +  - Room 
 +  - 16 note pre delay 
 +  - Plate and filter (manual) 
 +  - Plate and filter (auto) 
 +  - Spring 
 +  - Non-attack and metal 
 +  - High pass 
 + 
 +Delays: 
 + 
 +  - One head tape 
 +  - Three head tape 
 +  - Digital single delay 
 +  - Digital pan delay 
 +  - Reverse single delay 
 +  - Reverse pan delay 
 +  - Stereo flanger 
 +  - Bit crusher 
 + 
 +Sidechains (External In): 
 + 
 +  - Sin curve 
 +  - Square curve 
 +  - Saw squared curve 
 +  - Square gate 
 +  - Sin very short curve 
 +  - Saw squared long curve 
 +  - Square short gate 
 +  - Up down curve 
 + 
 +See also: https://rolandcorp.com.au/blog/tr-8-and-effects-part-1-onboard-effects 
 + 
 +?6 delays, 8 reverbs, 8 sidechain types, as well as a scatter section, flanger and a bit crusher.
  
 ===== Settings ===== ===== Settings =====
Line 49: Line 164:
  
 ==== Colours ==== ==== Colours ====
 +
 Hold ''DEPTH'' and rotate the ''SCATTER'' dial to select from different colours for the lights. When selected let go of ''DEPTH'' and hit ''START/STOP'' Hold ''DEPTH'' and rotate the ''SCATTER'' dial to select from different colours for the lights. When selected let go of ''DEPTH'' and hit ''START/STOP''
  
Line 75: Line 191:
  
 After booting into settings hold the A and B buttons to assign things. After booting into settings hold the A and B buttons to assign things.
 +
 +Anything not assigned will go to the regular mix output. If you take advantage of panning, by panning things completely to the left or right, this effectively gives you four outputs.
  
 ==== Volume ==== ==== Volume ====
Line 97: Line 215:
   * [[yt>elOpe5IYobk|Roland AIRA TR-8 Tutorial (Settings, Sequencing, FX, Sidechain)]] - Another one.   * [[yt>elOpe5IYobk|Roland AIRA TR-8 Tutorial (Settings, Sequencing, FX, Sidechain)]] - Another one.
   * https://www.rolandcorp.com.au/blog/ultimate-guide-aira-tr-8   * https://www.rolandcorp.com.au/blog/ultimate-guide-aira-tr-8
 +  * https://www.roland.com/global/support/by_product/tr-8/updates_drivers/
   * https://www.roland.com/global/support/by_product/tr-8/owners_manuals/   * https://www.roland.com/global/support/by_product/tr-8/owners_manuals/
   * [[https://tinyloops.com/doc/roland_tr-8/|Roland TR-8]] guide on tinyloops.com.   * [[https://tinyloops.com/doc/roland_tr-8/|Roland TR-8]] guide on tinyloops.com.
roland_tr-8.1716373827.txt.gz · Last modified: 2024/05/22 20:30 by rjt